Step 2- Set the numbers on the easel,for the (cmy).
Step 3 - Then set a grade on the filters.
Step 4 - Place the negative into the negative holder once you have selected the photo you want to develop.
Step 5 - Switch the light on, then figure out your aperture by seeing how it appears below, then change the aperture if the photo isn't clear enough, or if it is too dark or too bright.
Step 6 - Once you are satisfied with your image turn off the light and get a little or big sheet of paper.
Step 7 - It is good to do a test strip before you do your final image, it is good to do this because then it will give you an idea on how long your paper should be exposed for. Then to do your test strips get a medium sized piece of cared board and move it a bit further each time for each frame.
Step 8 - When it comes to developing the picture you need to put it in to the developer for 1 minuet.
Step 9 - Once it has been in the developer you put it into the stop bath for 30 seconds.
Step 10 - After the stop bath it goes into the fixer for a minuet.
Step 11 - After that it has to go into a water bath to clean for ten minuets.
Step 12 - Once you have a time you are happy with, you repeat these steps to a preferred time.
Step 5 - Switch the light on, then figure out your aperture by seeing how it appears below, then change the aperture if the photo isn't clear enough, or if it is too dark or too bright.
Step 6 - Once you are satisfied with your image turn off the light and get a little or big sheet of paper.
Step 7 - It is good to do a test strip before you do your final image, it is good to do this because then it will give you an idea on how long your paper should be exposed for. Then to do your test strips get a medium sized piece of cared board and move it a bit further each time for each frame.
Step 8 - When it comes to developing the picture you need to put it in to the developer for 1 minuet.
Step 9 - Once it has been in the developer you put it into the stop bath for 30 seconds.
Step 10 - After the stop bath it goes into the fixer for a minuet.
Step 11 - After that it has to go into a water bath to clean for ten minuets.
Step 12 - Once you have a time you are happy with, you repeat these steps to a preferred time.
No comments:
Post a Comment